Device FSP not being saved
-
- Posts: 19
- Joined: Tue Nov 01, 2011 9:26 am
Device FSP not being saved
Hi --
I'm running Madrix 5.5f. I have 4 SACN devices configured. I need them to run at 20FPS. I configured it in device manager. If configure 1 device, it makes all SACN devices same frame rate. That's fine. I save my Setup. Quit Madrix then load setup again. FPS defaults to 33.3. This is not ideal since I have Madrix set to load on boot then have the setup launch and start running a cue list.
Ideally configured FPS should be saved as part of the setup and loaded again. I've also tried saving the setup, but that doesn't do any good.
I'm running Madrix 5.5f. I have 4 SACN devices configured. I need them to run at 20FPS. I configured it in device manager. If configure 1 device, it makes all SACN devices same frame rate. That's fine. I save my Setup. Quit Madrix then load setup again. FPS defaults to 33.3. This is not ideal since I have Madrix set to load on boot then have the setup launch and start running a cue list.
Ideally configured FPS should be saved as part of the setup and loaded again. I've also tried saving the setup, but that doesn't do any good.
Re: Device FSP not being saved
Hello billinsofl,
Thank you for the report. Can you please double check it again?
The set sending FPS of sACN interfaces are saved in the setup.
At the moment we can't reproduce it here in the office. As soon as we load a setup the sending rate of the sACN nodes will be set respectively reloded to the saved values
Thank you for the report. Can you please double check it again?
The set sending FPS of sACN interfaces are saved in the setup.
At the moment we can't reproduce it here in the office. As soon as we load a setup the sending rate of the sACN nodes will be set respectively reloded to the saved values
-
- Posts: 19
- Joined: Tue Nov 01, 2011 9:26 am
Re: Device FSP not being saved
I've reproduced many many times. Perhaps it's something carried over from my Madrid3 setup file? I didn't recreate from scratch. I opened it and and Saved it in Madrix 5.
https://citrix.sharefile.com/d-s99316f7 ... ba18a4b41e
https://citrix.sharefile.com/d-s99316f7 ... ba18a4b41e
Re: Device FSP not being saved
Hello billinsofl,
When I test it with the shared MADRIX setup I can't dedect the explained problem.
Can you please share or send via e-mail a screen recorded video which shows the issue at the used PC?
If you want to send it via e-mail, please send it to info[at]madrix[dot]com
When I test it with the shared MADRIX setup I can't dedect the explained problem.
Can you please share or send via e-mail a screen recorded video which shows the issue at the used PC?
If you want to send it via e-mail, please send it to info[at]madrix[dot]com